CLASS RACER FORUM - View Single Post

rod · 08-26-2015, 07:53 PM

I have at least one pushrod guide plate, which needs to be split to get the rocker square on the valve stem.
since I assume these plates are hard, probably a band saw will not work [or will it?]. what is the best and or easiest way to split a plate?

Thanks Rod in AZ

08-26-2015, 07:53 PM	#1
rod Member Join Date: Dec 2009 Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66 Posts: 314 Likes: 0 Liked 20 Times in 15 Posts	SBC guide plate ? I have at least one pushrod guide plate, which needs to be split to get the rocker square on the valve stem. since I assume these plates are hard, probably a band saw will not work [or will it?]. what is the best and or easiest way to split a plate? Thanks Rod in AZ