Re: Radial tire "wobble" with the Super 10
the truck setup is good
*front end properly aligned
*same travel on each side both front and rear
*four link has 1/4 flat pre-load right upper bar [just take the slack out from neutral]
*anti-roll bar is neutral with slack taken out
*new AFCO shocks all four corners by Randy Mans of Fast Shocks. Shocks adjusted per our collaboration.
An above post suggest running the same air as I ran with bias tires [10 pounds] and judging by the photos that is good advice.
Truck is smooth and straight with bias tire.
__________________
Larry Woodfin 471W
|