CLASS RACER FORUM - View Single Post

CMcAllister · 12-21-2015, 09:26 PM

In the Chevelle we just did, it was a factory bucket seat car and we used the OE seat mounting points. It's a reinforced hard point, so we used that. But the centerline of the mounting points is not centered on the steering wheel and the seat had to be adjusted over with the mount to center it on the wheel. The Jaz seats we used are mounted about 2 1/4" from the floor to the bottom of the seat to get the best height for visibility, fitting in the cage, etc. We just determined where the seat would need to be and fabbed a CM tubular mount between the floor points and the seat. Made a mirror image piece for the passenger side and made a seat back brace attached to the crossbar..

12-21-2015, 09:26 PM	#3
CMcAllister Senior Member Join Date: Sep 2006 Location: Fulton County, PA Posts: 615 Likes: 17 Liked 920 Times in 259 Posts	Re: Racing seats In the Chevelle we just did, it was a factory bucket seat car and we used the OE seat mounting points. It's a reinforced hard point, so we used that. But the centerline of the mounting points is not centered on the steering wheel and the seat had to be adjusted over with the mount to center it on the wheel. The Jaz seats we used are mounted about 2 1/4" from the floor to the bottom of the seat to get the best height for visibility, fitting in the cage, etc. We just determined where the seat would need to be and fabbed a CM tubular mount between the floor points and the seat. Made a mirror image piece for the passenger side and made a seat back brace attached to the crossbar..