View Single Post
Old 12-23-2015, 03:48 PM   #7
Ed Wright
Veteran Member
 
Ed Wright's Avatar
 
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 390 Times in 170 Posts
Default Re: Cylinder head milling

Quote:
Originally Posted by Dwight Southerland View Post
Most accurate way to know how much to mill is to assemble the valves in the head, set it with combustion chamber up on a stand or braced so that the surface is perfectly level. Then pour the amount of combustion chamber volume into each chamber and measure to the surface of the liquid with a depth mike. Record the depth measurement for each chamber and you can average the amount to mill off the surface. No guessing and you can get it where you want in one cut.
Makes too much sense to do it this way. LOL
__________________
Ed Wright 4156 SS/JA
Ed Wright is offline   Reply With Quote