CLASS RACER FORUM - View Single Post

T-Bolt Racer · 01-13-2016, 10:08 AM

Did not modify any thing but had to slot the throw out bearing holder for my data recorder center the bell with offset dowels run a advance clutch but have a McLeod soft lock for a SOHC N/SS ( working out some intake issue)have a spare adv clutch I'll measure both and see the difference on the levers might call Hyatt racing service and see if they can lower the fingers GOD SPEED TIM Hyatt for lower installed hight? Measured today 1/14 the difference between the McLeod and adv clutches the leod is thinner by .270 from crank end to fingers.

01-13-2016, 10:08 AM	#5
T-Bolt Racer Junior Member Join Date: May 2013 Posts: 57 Likes: 0 Liked 0 Times in 0 Posts	Re: ford fe bellhousing Did not modify any thing but had to slot the throw out bearing holder for my data recorder center the bell with offset dowels run a advance clutch but have a McLeod soft lock for a SOHC N/SS ( working out some intake issue)have a spare adv clutch I'll measure both and see the difference on the levers might call Hyatt racing service and see if they can lower the fingers GOD SPEED TIM Hyatt for lower installed hight? Measured today 1/14 the difference between the McLeod and adv clutches the leod is thinner by .270 from crank end to fingers. Last edited by T-Bolt Racer; 01-14-2016 at 05:39 PM.