CLASS RACER FORUM - View Single Post

james schaechter · 01-07-2017, 11:49 PM

The throwoutbearing has spacers that you may have to take out To make it short enough. With a .380 disc it is pretty tight in there. Is it also shimmed between the flywheel and pp? You might have to put the QT spacer between the bell and block saver. I think the part number is rm-198. It is .250 thick. You would have to run a long pivot ball and check your crossmember and driveshaft fitment, but it opens up a lot more room for you.

01-07-2017, 11:49 PM	#9
james schaechter VIP Member Join Date: Dec 2004 Location: Cumming GA Posts: 1,992 Likes: 1,293 Liked 1,436 Times in 299 Posts	Re: Clutch Fork/Bellhousing Interference The throwoutbearing has spacers that you may have to take out To make it short enough. With a .380 disc it is pretty tight in there. Is it also shimmed between the flywheel and pp? You might have to put the QT spacer between the bell and block saver. I think the part number is rm-198. It is .250 thick. You would have to run a long pivot ball and check your crossmember and driveshaft fitment, but it opens up a lot more room for you. __________________ James Schaechter 3163 STK