View Single Post
Old 01-08-2017, 11:37 PM   #4
SSDiv6
VIP Member
 
Join Date: Feb 2003
Location: Glendale, Arizona
Posts: 3,045
Likes: 712
Liked 1,594 Times in 583 Posts
Default Re: 10 degree GM wedge heads

Quote:
Originally Posted by Mike Mans View Post
I have always been under the impression that CFE and SLAWKO are the only two that have really rolled the 615 castings over to 10*. I'm guessing some welding has taken place to allow that to happen, but I know it was never a GM casting that started at 10*.

Mike Mans
Mike, you are correct.
The 615x cylinder head as cast, can be rolled to 12 degrees. To achieve 10 degrees, a lot of more worked is required.

Last edited by SSDiv6; 01-08-2017 at 11:41 PM.
SSDiv6 is offline   Reply With Quote