CLASS RACER FORUM - View Single Post

Dissident · 06-06-2017, 10:24 PM

Forum Folks that might be interested in an easy solution to measuring QJet Hangers:
Easy to build out of scrap stuff. Center piece is 1/8" aluminum but could be steel or whatever. Bottom is built from couple of pieces of 3/4" x 1/8" angle iron so it is easy to keep upright when used. Will include a few photos for reference. Most folks do not need this kind of accuracy but it is easy to use anyway. Soon as I figure how to resize the pics that is.
Measure from the top surface to the pin (0.067" diam) with dial caliper.

Regards to All,
Dissident

06-06-2017, 10:24 PM	#9
Dissident Member Join Date: Jan 2016 Location: Colorado hills Posts: 123 Likes: 11 Liked 73 Times in 36 Posts	Re: Q Jet Secoundary Rods Forum Folks that might be interested in an easy solution to measuring QJet Hangers: Easy to build out of scrap stuff. Center piece is 1/8" aluminum but could be steel or whatever. Bottom is built from couple of pieces of 3/4" x 1/8" angle iron so it is easy to keep upright when used. Will include a few photos for reference. Most folks do not need this kind of accuracy but it is easy to use anyway. Soon as I figure how to resize the pics that is. Measure from the top surface to the pin (0.067" diam) with dial caliper. Regards to All, Dissident Attached Thumbnails Last edited by Dissident; 06-06-2017 at 10:33 PM.