CLASS RACER FORUM - View Single Post

ss3011 · 07-02-2018, 11:54 AM

Dan , what size wheel studs are you using , are they pressed in or threaded in the axle flange ? It is interesting that you had them loosen up , sounds like something was not seated properly .

I have always used Mark Williams 5/8" drive studs , which has an 11/16" shank which fits snuggly into the lug holes in my Weld Wheels . Never have had a problem with that setup . If you buy new axles , I would recommend switching to that setup .

07-02-2018, 11:54 AM	#17
ss3011 Senior Member Join Date: Feb 2002 Location: Southeast Michigan Posts: 909 Likes: 70 Liked 239 Times in 114 Posts	Re: Wheel Studs Dan , what size wheel studs are you using , are they pressed in or threaded in the axle flange ? It is interesting that you had them loosen up , sounds like something was not seated properly . I have always used Mark Williams 5/8" drive studs , which has an 11/16" shank which fits snuggly into the lug holes in my Weld Wheels . Never have had a problem with that setup . If you buy new axles , I would recommend switching to that setup .