Quote:
Originally Posted by Ron Gusack
Cam bearings are King's but I don't know part number. The pan is a 7 quart Moroso which is basically a stock pan with a deeper sump, nothing special. I run 6 quarts of Penn 10-30. It's possible that I have the pickup to close to the pan. I recently read a post that said it should be about 1/2" and I've always put mine at 1/4 to 3/8.
|
I run the pick up .310 off the bottom of the pan. I use coated Durabond cam bearings. The Durabond CH12 bearings go oval, never use these, especially if clearance isn't maintained. 6 quarts is fine if there's no excessive leaks. What is inside your pan?