Quote:
Originally Posted by Mark Yacavone
Okay. First step is take the pedal out and drill a hole about an inch up. They are case hardened , so use a drill press.
That's the free one , before getting out the Plasti-Card.
|
Umm, If it is actually
Case Hardened, A solid carbide drill bit is not going through it. I like the welding in an extra 2", that
will give more leverage but will put the pedal close to the floor.
My car has 2 stubs welded on the brake pedal lever from the factory. I also put as large of a Rear wheel cylinder I could find on the Fronts. (4 wheel drums)