CLASS RACER FORUM - View Single Post

Dave Muller · 05-12-2019, 07:07 PM

I'll know more tomorrow morning when the distributor comes out, but my plan at the moment is to remove the gear, pull up enough to be able to slip in one or more flat washers as needed to take up the gap, then reassemble. With the right thickness of washers it should hold the plates together firmly when I tighten down on the nut.

Totally reversible too.

05-12-2019, 07:07 PM	#9
Dave Muller Member Join Date: Apr 2014 Location: Mesa, AZ Posts: 497 Likes: 162 Liked 223 Times in 73 Posts	Re: Locked out distributor advance question I'll know more tomorrow morning when the distributor comes out, but my plan at the moment is to remove the gear, pull up enough to be able to slip in one or more flat washers as needed to take up the gap, then reassemble. With the right thickness of washers it should hold the plates together firmly when I tighten down on the nut. Totally reversible too.