View Single Post
Old 10-07-2019, 10:35 AM   #7
Steve Stasko
Member
 
Join Date: Jul 2011
Location: Western PA
Posts: 455
Likes: 13
Liked 274 Times in 143 Posts
Default Re: Engine diapers on S/SS?

Quote:
Originally Posted by Larry Hill View Post
After looking at the B-E body engine, steering, and headers on my stocker, it would be a lot of work and expense. The drag link runs real close to the sump and the bottom of pan, this could be a potential crash if the Kevlar blanket jams the steering. A motor plate would not help the steering situation. A tray might work until a big wheel stand. When that happens on my car it bends the oil pan against the pickup, and bends the transmission pan. The oil pan I have to fix before I make the next run. If new ss headers are needed to complete the ORD I will be done.
All of a sudden cutting bait doesn't look so bad.
I must have done something wrong on my '64 Dodge when I put the engine diaper on it. I have the factory K-frame, steering, and torsion bars. Using 1 3/4" Hooker S/C headers (one tube through fenderwell). I fit a universal Jeg's diaper on the car without issue, though I did have to get creative with some of the mounting points for the support straps to hold it up.

I wasn't real fond of putting it on, but when the rules require it (I ran the car in S/ST a few times...ex-SS car), you find a way to make it work if you want to race.

While the Jeg's diaper doesn't provide the best fit, I can only imagine how much better the job would have been had I used something that was designed for the car.
Steve Stasko is offline   Reply With Quote