CLASS RACER FORUM - View Single Post

Jeff Stout · 10-16-2019, 12:06 PM

Going through this right now. I was at 13% and tested using John Deere Hydraulic oil and dropped 300 RPM. I think I'm at 9% now. It was just an experiment and now will remove converter to tighten up top end and hopefully keep starting line rpm the same. Debating on what to get converter set at because I race from 2000ft to 6500ft of air throughout the year and don't want to change converters.

10-16-2019, 12:06 PM	#3
Jeff Stout VIP Member Join Date: Dec 2001 Location: phoenix Posts: 1,486 Likes: 66 Liked 704 Times in 281 Posts	Re: Converter Slippage at top end Going through this right now. I was at 13% and tested using John Deere Hydraulic oil and dropped 300 RPM. I think I'm at 9% now. It was just an experiment and now will remove converter to tighten up top end and hopefully keep starting line rpm the same. Debating on what to get converter set at because I race from 2000ft to 6500ft of air throughout the year and don't want to change converters.