View Single Post
Old 11-14-2019, 01:21 PM   #102
Steve Polhill
Senior Member
 
Steve Polhill's Avatar
 
Join Date: May 2003
Location: London Ontario
Posts: 515
Likes: 40
Liked 262 Times in 74 Posts
Default Re: Where did the FWD stockers go?

Quote:
Originally Posted by Dave Noll View Post
Without a posi (or welded 🕷️ gears) getting a burnout that yielded a 60ft better than no burnout happened only once. That was the 2.15. That one bit but everything else is spinning a little. The waterbox guys tell me it spins one side a little and then the other. So I don't think I'll bother with a burnout anymore. Until I get the diff fixed, I can't accurately say how it "hits". 4k was a decent leave.

If you aren't going to run a Posi/Spool don't do a burnout. With one wheel spinning faster than the other the side gears stick to the diff pin. That snaps the retaining bolt, the pin comes out hits the case and cracks it wide open. Ask me how I know LOL
__________________
Steve Polhill
3520 STOCK, COMP
Steve Polhill is offline   Reply With Quote
Liked