[Rory Christianson]

Hey csjta

OK I tried adapter no luck

Then I put the cable into the 9 port and left the key in the 25 port....And YES now I can access the tables for ignition, start up, and RPM

So currently it is set up at 15 degrees in the Accel.......and the RPM is at 360
So it would appear to me in crank mode it is giving it like 47 degrees total counting say 32 in the distributor..........does that sound right to you ?

So I was thinking of dropping the timing down to 0 degrees and bumping up the RPM up to about 550 or 600 scale only goes to 600............does any of that sound right to you ?

On the timing graph it looks like it bases it off of engine temp, so I am not sure on the graph how long to leave it at 0 before it scales up ?............is that just a trial and error thing.......I would think as soon as it starts it comes off this scale and goes to other settings

Thanks again for all your help