CLASS RACER FORUM - View Single Post

Project 392 · 12-05-2021, 06:14 PM

Thanks all.
It's probably a moot point on who made them. They are brand new. Just need to mock it up to make sure the body groove doesn't uncover the lifter oil galley passage for a pressure loss at lift.

Tom, I have one block that is sleeved and set up for chebby lifters and
ford tie bars like you did.

Looking to see what else I need to build two motors with the parts I have on hand. One will be a street/strip with ported iron heads and a 4 speed. The other is a Fred Brewer headed 427 AMC, sheet metal intake with Turbo 400.

Thanks again,

Victor in Kingman

12-05-2021, 06:14 PM	#4
Project 392 Junior Member Join Date: Mar 2018 Posts: 40 Likes: 196 Liked 26 Times in 15 Posts	Re: AMC roller lifters Thanks all. It's probably a moot point on who made them. They are brand new. Just need to mock it up to make sure the body groove doesn't uncover the lifter oil galley passage for a pressure loss at lift. Tom, I have one block that is sleeved and set up for chebby lifters and ford tie bars like you did. Looking to see what else I need to build two motors with the parts I have on hand. One will be a street/strip with ported iron heads and a 4 speed. The other is a Fred Brewer headed 427 AMC, sheet metal intake with Turbo 400. Thanks again, Victor in Kingman