CLASS RACER FORUM - View Single Post

L.Fite · 05-02-2022, 08:59 PM

Those were the go to manifolds in the 70s.

I had a square port Tarantula on a 427 in the early 80s.
Ran 11.60s in '67 Camaro, street legal car w/mufflers, 3250#, 10.5W tire, 4.88 rear, TH400 w/3500 stall, hydraulic cam, 750 Holley

Saw a lot of Scorpions on SBC back then.

I seem to remember seeing the breather tubes blocked with a freeze plug on some intakes that had that.
They pre-dated the Victor series stuff.

That was a long time ago...

05-02-2022, 08:59 PM	#2
L.Fite Senior Member Join Date: May 2020 Posts: 517 Likes: 553 Liked 497 Times in 243 Posts	Re: Edelbrock Scorpion & Tarantula Manifolds Those were the go to manifolds in the 70s. I had a square port Tarantula on a 427 in the early 80s. Ran 11.60s in '67 Camaro, street legal car w/mufflers, 3250#, 10.5W tire, 4.88 rear, TH400 w/3500 stall, hydraulic cam, 750 Holley Saw a lot of Scorpions on SBC back then. I seem to remember seeing the breather tubes blocked with a freeze plug on some intakes that had that. They pre-dated the Victor series stuff. That was a long time ago...