CLASS RACER FORUM - View Single Post

Jack Zimmerman · 07-13-2024, 07:55 AM

I also have a JD2 bender but they don't make a Model 3 anymore and the Model 32 is the replacement. But I'm cheap so I used an 8-ton, air over hydraulic jack ram from Harbor Freight to power it (~$120) and I built a roll around stand for the whole thing and it seems to work pretty well so far. If you're interested in that option there are lots of comments, pictures and videos on the internet for how to do it.

07-13-2024, 07:55 AM	#7
Jack Zimmerman Junior Member Join Date: Dec 2001 Location: Clemmons, NC Posts: 35 Likes: 0 Liked 11 Times in 6 Posts	Re: roll bar bending tools I also have a JD2 bender but they don't make a Model 3 anymore and the Model 32 is the replacement. But I'm cheap so I used an 8-ton, air over hydraulic jack ram from Harbor Freight to power it (~$120) and I built a roll around stand for the whole thing and it seems to work pretty well so far. If you're interested in that option there are lots of comments, pictures and videos on the internet for how to do it.