CLASS RACER FORUM - View Single Post

NORMAN BARNARD · 08-28-2008, 10:05 PM

Bub, thanks for the info. I'll check the casting number again tomorrow at the shop to make sure i didn't make a mistake. The thing about this manifold that caught my eye was the "factory cast" bosses in two of the intake runners on each side that are drilled and taped with a 1/8th pipe tap, nothing like i've seen before and no sign's of any modification (welding) and i've been playing this game for 50 years, but eye sight and memory aren't what they use to be.

Thanks again for the input.......

08-28-2008, 10:05 PM	#3
NORMAN BARNARD Member Join Date: Mar 2006 Location: EL PASO, TEXAS Posts: 156 Likes: 0 Liked 2 Times in 2 Posts	Re: Small block intake identification Bub, thanks for the info. I'll check the casting number again tomorrow at the shop to make sure i didn't make a mistake. The thing about this manifold that caught my eye was the "factory cast" bosses in two of the intake runners on each side that are drilled and taped with a 1/8th pipe tap, nothing like i've seen before and no sign's of any modification (welding) and i've been playing this game for 50 years, but eye sight and memory aren't what they use to be. Thanks again for the input.......