CLASS RACER FORUM - View Single Post

Larry Hill · 06-10-2019, 08:10 AM

I got to use a Total Seal Ring Filer to set end gap on my rings. What a quality piece of equipment. I practiced on an old ring to get the feel of increasing as little as .0005'', I think, end gap. It has a deburring wheel for the ends of the ring, for me that will take a little practice. I prefer using a Dremel tool with an rubber abrasive wheel to deburr. Ends of the ring were 90* and parallel, all I had to do was follow directions.

I have tried the Pro Form filer and it is just a classic example of junk off the "Boat" that does not repeat.

It's time for the blocks final bath before assembly, yes!

06-10-2019, 08:10 AM	#89
Larry Hill Live Reporter Join Date: Oct 2004 Location: Hickory, Ky Posts: 10,281 Likes: 1,637 Liked 9,456 Times in 1,957 Posts	Re: Dumbo The Flying Elephant I got to use a Total Seal Ring Filer to set end gap on my rings. What a quality piece of equipment. I practiced on an old ring to get the feel of increasing as little as .0005'', I think, end gap. It has a deburring wheel for the ends of the ring, for me that will take a little practice. I prefer using a Dremel tool with an rubber abrasive wheel to deburr. Ends of the ring were 90* and parallel, all I had to do was follow directions. I have tried the Pro Form filer and it is just a classic example of junk off the "Boat" that does not repeat. It's time for the blocks final bath before assembly, yes! __________________ IHM Used Parts https://ihmusedparts.com 888-821-1817