The roll cage was a pre-bent Jegster kit. All in all I thought the kit was fairly well put together. The bends had some deformation which is expected with a non mandrel bent tube but all of the required pieces were there. I used an 1 5/8” hole saw and a carbide bit to make all of the fish mouths. I’m by no means a fabricator but the welds and fitment are presentable. The welds were made with the Miller TIG.
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us
Uploaded with
ImageShack.us