[Dion Hildebrandt]

-And more
-I had been struggling with the fuel cell, weight box, fuel pump and fuel filter mount.and there isn't a lot of photographic examples around for comparision....so what does a guy do?
-I studied the rule books of both sanctioning bodies and came up with what I think is an acceptable solution.....we will eventually find out. The tubing is 3/4 inch with a good wall thickness, where any bolt goes through it is sleeved, I have some gusseting left to do yet
-The fuel filter will be moved as it seemed a good place while mocking up the unit, upon completion I don't like it at all. 90degree turns and short runs of plumbing spell It Is Going To Be Changed!!
-The unit mounts to the roll bar plate area ,that uses 1/2 inch bolts which is overkill according to the rules. The bolts run through the rear frame rail and are sleeved to prevent crushing of the frame and plated where the bolts run through the floor pan only.