|
07-02-2007, 03:21 PM | #1 |
Junior Member
Join Date: Sep 2004
Posts: 14
Likes: 0
Liked 0 Times in 0 Posts
|
Jacks
Does anyone have any pictures of Ron Erks car sitting on a set of jacks from the Norwalk event this weekend? ProJack just came out with a set of jacks that works for sportman dragsters & would like to see a picture of them.
Thanks. |
07-05-2007, 05:52 PM | #2 |
Member
|
Re: Jacks
I do not have a picture however did look at it and see how it was done, simply there were two projacks back to back, so the parts that normally face outwards on door cars were touching in the area under the blowshield.
I didn't look like any special projack just two of them touching and set far back on the chassis (because of the extreme weight differences from front to back. From the ****pit forward was just hanging in the air with nothing under it. |
07-06-2007, 10:06 AM | #3 |
Junior Member
Join Date: Sep 2004
Posts: 14
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Jacks
Chris,
I looked at these also. They are different then there regular jacks as they only use 1 cylinder to operate both jacks & pin together. I know this is a brand new design built especially for sportsman dragsters. I was sent a picture but it is not very good. |
07-08-2007, 07:04 PM | #4 |
Member
Join Date: Nov 2005
Location: Waxahachie, Texas
Posts: 244
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Jacks
Contact Marc Erickson @ autometer. Here is is email address:marc_erickson@autometer.com They are very nice jacks.
Bighead |
|
|