|
|
07-04-2011, 09:44 PM
|
#1 |
|
Junior Member
Join Date: Dec 2007
Posts: 38
Likes: 0
Liked 2 Times in 2 Posts
|
Painless Wiring System
I bought a 69 Barracuda that came with a painless wiring system and it had a tach in it with 3 wires. The tach I'm putting in has 4 wires and is an Autometer Carbon Fiber with a shift light. I know one wire goes to the lights, one to the ground and one to a 12 volt source. Where does the other wire go? Could someone help me to get this tach to work. There is also a 6AL MSD and blaster coil.
Thanks |
|
|
|
07-04-2011, 09:55 PM
|
#2 |
|
Member
Join Date: Dec 2001
Location: Hanover, MA
Posts: 430
Likes: 3
Liked 1 Time in 1 Post
|
Re: Painless Wiring System
The green wire goes to the terminal on the side of the MSD box.
__________________
Doug Blackley 1697 STK |
|
|
|
|
07-05-2011, 09:05 PM
|
#3 |
|
Junior Member
Join Date: Dec 2007
Posts: 38
Likes: 0
Liked 2 Times in 2 Posts
|
Re: Painless Wiring System
Thanks
|
|
|
|
|
07-05-2011, 09:27 PM
|
#4 |
|
Junior Member
Join Date: May 2009
Posts: 91
Likes: 77
Liked 32 Times in 9 Posts
|
Re: Painless Wiring System
Green = MSD or coil
White = Dash lights Red = 12v switched Ignition Black = Ground Blue = Clutch switch or line lock Mark Madison |
|
|
|
|
07-06-2011, 09:21 PM
|
#5 |
|
Junior Member
Join Date: Dec 2007
Posts: 38
Likes: 0
Liked 2 Times in 2 Posts
|
Re: Painless Wiring System
thanks for the info
|
|
|
|
 |
|
|
Linear Mode
