4500 to 4150

mannymen · 11-03-2010, 03:28 PM

Does anyone make a 1 inch spacer that adapts a 4500 base to a 4150 carb base? I already have a 2 inch adapter, but hood clearance is an issue with the 2 inch.

Thanks

Mike Taylor 3601 · 11-03-2010, 03:49 PM

Mr gasket use to have I don't have catalog for Mr Gasket to give part# can find tonight if you need it. they were 1'' thick and had offset studs would adapt either direction
Mike Taylor3601

mannymen · 11-04-2010, 01:23 PM

Mike was that PN 1930?

Jeff Lee · 11-04-2010, 04:08 PM

http://www.wilsonmanifolds.com/produ...-adapters.html

Can't you just flip it upside down?

11-03-2010, 03:28 PM	#1
mannymen Senior Member Join Date: Apr 2003 Posts: 728 Likes: 5 Liked 13 Times in 7 Posts	4500 to 4150 Does anyone make a 1 inch spacer that adapts a 4500 base to a 4150 carb base? I already have a 2 inch adapter, but hood clearance is an issue with the 2 inch. Thanks __________________ N/A

11-03-2010, 03:49 PM	#2
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,372 Likes: 358 Liked 308 Times in 103 Posts	Re: 4500 to 4150 Mr gasket use to have I don't have catalog for Mr Gasket to give part# can find tonight if you need it. they were 1'' thick and had offset studs would adapt either direction Mike Taylor3601

11-04-2010, 01:23 PM	#3
mannymen Senior Member Join Date: Apr 2003 Posts: 728 Likes: 5 Liked 13 Times in 7 Posts	Re: 4500 to 4150 Mike was that PN 1930? __________________ N/A

11-04-2010, 04:08 PM	#4
Jeff Lee VIP Member Join Date: Jul 2007 Location: Anthem, Arizona Posts: 2,766 Likes: 0 Liked 3 Times in 3 Posts	Re: 4500 to 4150 http://www.wilsonmanifolds.com/produ...-adapters.html Can't you just flip it upside down? __________________ Jeff Lee 7494 D/S '70 AMX

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode