|
|
![]() |
#1 |
Member
Join Date: Jul 2009
Location: Bulington, Ky
Posts: 359
Likes: 0
Liked 6 Times in 5 Posts
|
![]()
We are having issues with the car as soon as you release the trans brake and it leaves the line and starts in the air it hesitates and acts like it is out of fuel. We have change 3 different carbs and regulator, fuel pump, msd box, we have looked at rotor button, distributor cap, and when car lands to runs fine and comes clean out of water boxs. any input would be helpful. thanks
|
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Mar 2002
Posts: 1,106
Likes: 57
Liked 507 Times in 116 Posts
|
![]()
What car, engine, carb?
__________________
68 Chevy11 327 F/S |
![]() |
![]() |
![]() |
#3 |
VIP Member
Join Date: Jul 2007
Location: Anthem, Arizona
Posts: 2,766
Likes: 0
Liked 3 Times in 3 Posts
|
![]()
If it runs fine everywhere except "x", then "x" is the only issue.
Running out of fuel either due to pressure or just's uncovered or sloshing fuel where it's not supposed to be. Maybe a wedge plate will work? But you have to look at the whole picture.
__________________
Jeff Lee 7494 D/S '70 AMX |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Jul 2009
Location: Bulington, Ky
Posts: 359
Likes: 0
Liked 6 Times in 5 Posts
|
![]()
The car is a camaro, engine is a 350 and carb is a quadrajet. As far as Jeff's reply I don't understand what he's saying?? If the fuel pressure is off, then what should it be??
![]() ![]() |
![]() |
![]() |
![]() |
#5 |
VIP Member
Join Date: Jul 2008
Location: Liberty City [East Texas]
Posts: 1,760
Likes: 5
Liked 99 Times in 60 Posts
|
![]()
Jones,
judging by your first post you have checked the basics for a bad part. So, it is reasonable to look at other items. [and do not mean any disrespect, just beginning the brainstorming process] begin looking at the entire package in a different light. That is to say, go back and look carefully at every small thing. Look at every wire, every ground, every terminal connection, etc. One idea is to have someone else drive the car while you look and listen, might give a different idea of what is happening.
__________________
Larry Woodfin 471W |
![]() |
![]() |
![]() |
#6 |
VIP Member
Join Date: Jun 2002
Location: New Holland, PA Mooresville,NC
Posts: 1,163
Likes: 241
Liked 16 Times in 11 Posts
|
![]()
Fuel pressure or bad ground that only happens when you do a wheelie would be where I would start.
__________________
Bob Pagano A/SA |
![]() |
![]() |
![]() |
#7 |
Member
Join Date: Jul 2009
Location: Bulington, Ky
Posts: 359
Likes: 0
Liked 6 Times in 5 Posts
|
![]()
And just to add the car is still in low gear. and I did have the trans brake button break on me and the wires touch. Do you think that the trans brake button by touching could have shorted sum thing out?
![]() |
![]() |
![]() |
![]() |
#8 | |
Live Reporter
Join Date: May 2006
Location: Dripping Springs, Tx
Posts: 2,709
Likes: 186
Liked 520 Times in 132 Posts
|
![]() Quote:
__________________
Ed Carpenter 2005 Chevy Cobalt A/SM Race Engine Development |
|
![]() |
![]() |
![]() |
#9 |
Member
Join Date: Jul 2009
Location: Bulington, Ky
Posts: 359
Likes: 0
Liked 6 Times in 5 Posts
|
![]()
thanks to All for the help!!!!!!!!! Still Looking!!!!
|
![]() |
![]() |
![]() |
#10 |
Senior Member
Join Date: Apr 2007
Location: ILLINIOS
Posts: 715
Likes: 2
Liked 21 Times in 6 Posts
|
![]()
We had the same problem sometimes on the 88 Cutlass S/S move the regulator in front of the carb that way when the car launches the fuel in line will feed to bowl .
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|