rocker geometry

Weekend Racer · 06-07-2012, 08:34 PM

I am trying to use the Jim Miller rocker arm geometry on my jesel stand to put the roller in the center of the valve tip at mild lift.Once the mathematic are done this tell me to drop the stand .097.Once the stand are drop ,I check the print at mid lift. Here the problem .The print have shift well over the center line to the exhaust side .?

I am becoming crazy
Have any input on this set-up or a better way to ajust rocker arm stand geometry
thank!

Alan Roehrich · 06-07-2012, 08:52 PM

I'd suggest you call T&D, and do it their way.

06-07-2012, 08:34 PM	#1
Weekend Racer Junior Member Join Date: Feb 2003 Location: P.Q. Posts: 68 Likes: 1 Liked 1 Time in 1 Post	rocker geometry I am trying to use the Jim Miller rocker arm geometry on my jesel stand to put the roller in the center of the valve tip at mild lift.Once the mathematic are done this tell me to drop the stand .097.Once the stand are drop ,I check the print at mid lift. Here the problem .The print have shift well over the center line to the exhaust side .? I am becoming crazy Have any input on this set-up or a better way to ajust rocker arm stand geometry thank!

06-07-2012, 08:52 PM	#2
Alan Roehrich Veteran Member Join Date: May 2006 Location: Murfreesboro TN Posts: 5,114 Likes: 1,572 Liked 1,827 Times in 414 Posts	Re: rocker geometry I'd suggest you call T&D, and do it their way. __________________ Alan Roehrich 212A G/S