|
|
05-14-2017, 09:14 PM
|
#1 |
|
Junior Member
Join Date: May 2006
Posts: 96
Likes: 120
Liked 53 Times in 16 Posts
|
Drag Pak complete 8 3/4 rear axle assembly
Complete big pinion 4.86 axle assembly out of 2009 Drag Pak. 33 spline gun drilled axles, lightweight spool, 5/8 studs, strengthened Moser housing, billet yoke and anti-roll control bar. $1000.
|
|
|
|
05-16-2017, 10:23 PM
|
#2 |
|
Junior Member
Join Date: Mar 2015
Posts: 4
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Drag Pak complete 8 3/4 rear axle assembly
Does this have the aluminum centre section?
|
|
|
|
|
05-21-2017, 09:10 PM
|
#3 |
|
Junior Member
Join Date: May 2006
Posts: 96
Likes: 120
Liked 53 Times in 16 Posts
|
Re: Drag Pak complete 8 3/4 rear axle assembly
It is not an aluminum case. It is a "489" heavy duty cast iron case. Came out of my 2009 Drag Pak after putting a nine inch in it for SS.
|
|
|
|
|
05-22-2017, 01:42 AM
|
#4 |
|
VIP Member
Join Date: Jun 2009
Location: Boulder City, Nevada 89005
Posts: 2,737
Likes: 2,813
Liked 2,489 Times in 699 Posts
|
Re: Drag Pak complete 8 3/4 rear axle assembly
Where are you located?
__________________
John Irving 741 Stock 741 Super Stock |
|
|
|
|
05-30-2017, 08:03 PM
|
#5 |
|
Junior Member
Join Date: May 2006
Posts: 96
Likes: 120
Liked 53 Times in 16 Posts
|
Re: Drag Pak complete 8 3/4 rear axle assembly
In Ohio. John it is out of my Drag Pak, I put a 9 inch Ford in it when I went to SS and a trans brake. Keith Lynch 937-564-7991 if you need more info.
|
|
|
|
 |
|
|
Linear Mode
