driveshaft speed sensor

L79racer · 01-14-2018, 03:54 PM

Can someone let me know the pin out configuration for the autometer drive shaft speed sensor? I want to use it with my mega squirt ecm. What color is ground, power and signal? I cold not find it on their website. Thanks.

FED 387 · 01-14-2018, 04:10 PM

Black is ground white is signal red is power that's the way we always run it Fed

L79racer · 01-14-2018, 06:21 PM

Thanks Fed!! Im going to reuse my cable also that went to my tach. The end of the jumper cable at the sensor has a three wire connector but the other end that goes by the tach has a 4 wire connector. Is the fourth pin a shield?

L79racer · 01-22-2018, 08:39 PM

Fed 387 or anyone else tell me what the placement in the connector for the power ground and signal is? looking left to right with clip up just like the picture.. Thanks for the help. Im making up a new cable from the sensor to my ecu.

L79racer · 01-23-2018, 10:33 AM

Ok, have the info I need. Ill post it here in case someone else will need it one day.

Connector has terminals marked A,B,C

A -Blue is ground
B- black is signal
C- tan is 12 volts

01-14-2018, 03:54 PM	#1
L79racer Member Join Date: Jan 2005 Location: North Massapequa, NY Posts: 218 Likes: 0 Liked 0 Times in 0 Posts	driveshaft speed sensor Can someone let me know the pin out configuration for the autometer drive shaft speed sensor? I want to use it with my mega squirt ecm. What color is ground, power and signal? I cold not find it on their website. Thanks.

01-14-2018, 04:10 PM	#2
FED 387 VIP Member Join Date: Jun 2006 Posts: 3,400 Likes: 482 Liked 320 Times in 172 Posts	Re: driveshaft speed sensor Black is ground white is signal red is power that's the way we always run it Fed

01-14-2018, 06:21 PM	#3
L79racer Member Join Date: Jan 2005 Location: North Massapequa, NY Posts: 218 Likes: 0 Liked 0 Times in 0 Posts	Re: driveshaft speed sensor Thanks Fed!! Im going to reuse my cable also that went to my tach. The end of the jumper cable at the sensor has a three wire connector but the other end that goes by the tach has a 4 wire connector. Is the fourth pin a shield? Last edited by L79racer; 01-14-2018 at 06:24 PM.

01-22-2018, 08:39 PM	#4
L79racer Member Join Date: Jan 2005 Location: North Massapequa, NY Posts: 218 Likes: 0 Liked 0 Times in 0 Posts	Re: driveshaft speed sensor Fed 387 or anyone else tell me what the placement in the connector for the power ground and signal is? looking left to right with clip up just like the picture.. Thanks for the help. Im making up a new cable from the sensor to my ecu.

01-23-2018, 10:33 AM	#5
L79racer Member Join Date: Jan 2005 Location: North Massapequa, NY Posts: 218 Likes: 0 Liked 0 Times in 0 Posts	Re: driveshaft speed sensor Ok, have the info I need. Ill post it here in case someone else will need it one day. Connector has terminals marked A,B,C A -Blue is ground B- black is signal C- tan is 12 volts