|
|
![]() |
#1 |
Member
Join Date: Jul 2012
Location: Phoenix, Az
Posts: 320
Likes: 17
Liked 118 Times in 41 Posts
|
![]()
On my 79 Mustang stocker I want to leave the back seat in. My Roll bar will go thru the speaker holes. my question is, do I still have to put in a aluminum rear firewall behind the seat, due to the fuel cell in the trunk, or will it be ok without it?
__________________
U/SA 79 Mustang |
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Dec 2006
Location: West Virginia
Posts: 1,366
Likes: 6
Liked 70 Times in 29 Posts
|
![]()
I would say the answer is yes because the seat doesn't close the area off clear to the glass. I would do it anyway for my own safety even if it wasn't required by rule.
__________________
Chris Bowman The Mountain State Mustang 1984 Mustang GT350 |
![]() |
![]() |
![]() |
#3 |
VIP Member
Join Date: Aug 2011
Location: Fife, Washington
Posts: 1,985
Likes: 2,487
Liked 2,967 Times in 713 Posts
|
![]()
According to the 2017 rule book if a fuel cell is used you must remove the stock tank. The panel between the trunk and the interior must be covered with either .032 aluminum or .024 steel. Hope this helps you.
__________________
Ron McDowell - Did Race Every day is a Gift - Enjoy with family and friends. |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Jul 2012
Location: Phoenix, Az
Posts: 320
Likes: 17
Liked 118 Times in 41 Posts
|
![]()
Thats the way I read it too but it never hurts to ask people who know for sure.
![]()
__________________
U/SA 79 Mustang |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Mar 2006
Posts: 977
Likes: 797
Liked 275 Times in 76 Posts
|
![]()
With a hatch you will need to seal off the hatch to separate the trunk area from the driver's compartment no matter what you do. If it's a notchback, then you will still need to add the firewall. I have had tech people inspect how I sealed the hatch more than anything else on my car at multiple divisions. Since you have a notch back, you will need to cover the backseat and possibly the deck plate where the speakers/rollbar is. Make it seal good and no gaps otherwise it could be questioned.
Sean
__________________
Sean Marconette 84 Mustang 5060 SS/N |
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Jul 2012
Location: Phoenix, Az
Posts: 320
Likes: 17
Liked 118 Times in 41 Posts
|
![]()
What is the best thing to use to seal it with?
__________________
U/SA 79 Mustang |
![]() |
![]() |
![]() |
|
|