Stocker Roll Bar

[Dan Fahey]

Live in Montgomery County, MD - Rockville/Germantown

Need a NHRA Certified Roll Bar Installed !

Who and where can I get this done?

Dan

[Hacksaw]

You want one of the best? Ken Keir Race Cars.

[Lenny5160]

Is there such thing as a NHRA certified roll bar?

[Hacksaw]

Originally Posted by Lenny5160

Is there such thing as a NHRA certified roll bar?

You are correct, there is no " certification " , but there are min. requirements, ie: 1.75" tubing with a min. of .118 on the wall on mild steel as well as proper mounting methods.

[Dan Fahey]

Originally Posted by Hacksaw

You want one of the best? Ken Keir Race Cars.

Thanks for the information...

Does it make any difference to buy one pre-made or have it custom fitted?

Dan

[Lee Valentine]

Dan, I've used pre made kits from S&W and had good luck. Make sure the bar is installed as per the rule book.

[ALMACK]

Originally Posted by Lee Valentine

Dan, I've used pre made kits from S&W and had good luck. Make sure the bar is installed as per the rule book.

^^ I agree.

Both of my Stockers have S&W kits.
Very pleased with their quality and customer service.


One thing I did find out after installing the kit in my 2009 Stocker :

If I had special ordered a "relaxed fit" main hoop cross bar with a 2-3 inch set back ( instead of the normal straight piece) then my seats could
have reclined further back. I did not know this until after I installed the kit.

Being a novice at roll bar installations, I can now see why chassis shops charge so much. To fit things right it takes a lot of time

[Dan Fahey]

Originally Posted by ALMACK

^^ I agree.

Both of my Stockers have S&W kits.
Very pleased with their quality and customer service.


One thing I did find out after installing the kit in my 2009 Stocker :

If I had special ordered a "relaxed fit" main hoop cross bar with a 2-3 inch set back ( instead of the normal straight piece) then my seats could
have reclined further back. I did not know this until after I installed the kit.

Being a novice at roll bar installations, I can now see why chassis shops charge so much. To fit things right it takes a lot of time

This good information !!

Would like a Roll Bar setup where you can get out of the Seat easily without being Gumby !
Also be able to sit in the back seat.

Thanks

Dan

[Hacksaw]

Originally Posted by Dan Fahey

Thanks for the information...

Does it make any difference to buy one pre-made or have it custom fitted?

Dan

Most kits on the market are .134" tubing to make sure it meets the min. of .118". A quality shop will use .120" or .125" and check the thickness to make sure it will pass. They may have to buy DOM tube, more money, better product.