|
|
|
|
08-21-2021, 10:16 PM
|
#1 |
|
Live Reporter
Join Date: Oct 2004
Location: Hickory, Ky
Posts: 10,612
Likes: 1,896
Liked 10,650 Times in 2,209 Posts
|
Micro Welding of bearing shell to rod housing bore
Any ideas ?
Could it be when the combustion occurs the bearings take a hit in the middle causing the outer parts of the shell to move away from the housing just slightly and then return causing a fretting action and transfer of metal, from shell to housing bore. |
|
|
|
08-22-2021, 03:37 AM
|
#2 |
|
Junior Member
Join Date: Jul 2018
Posts: 3
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
Rods out of round or inadequate bearing crush. I'm just spit balling ideas.
|
|
|
|
08-22-2021, 08:16 AM
|
#3 |
|
VIP Member
Join Date: Dec 2001
Location: Texarkana Ark/TX
Posts: 2,446
Likes: 575
Liked 880 Times in 311 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
Bearing type/part number and rod type and application?
General answer: Fit in housing bore Pictures?
__________________
Adger Smith (Former SS) |
|
|
|
| Liked |
|
08-22-2021, 09:18 AM
|
#4 |
|
Live Reporter
Join Date: Oct 2004
Location: Hickory, Ky
Posts: 10,612
Likes: 1,896
Liked 10,650 Times in 2,209 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
Manley rods, King not as bad as Clevite 77, housing bore round according to AG 300. No pictures all the evidence is gone, removed.
How is bearing crush measured and where can the specifications be found? Oil is semi synthetic |
|
|
|
|
08-22-2021, 09:32 AM
|
#5 |
|
Member
Join Date: Aug 2010
Location: CT
Posts: 454
Likes: 1,767
Liked 345 Times in 149 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
I don't know if it's correct or not, but I use a height gauge to measure each shell and to verify that the shells are square, which I've found some that are way off. I've had rods on the small end of spec as well as the big side both do it.
__________________
Phil Molski PMR Performance S/C 1623 |
|
|
|
|
08-22-2021, 11:20 AM
|
#6 |
|
VIP Member
Join Date: Jun 2006
Posts: 3,409
Likes: 504
Liked 328 Times in 176 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
using too thin of an oil ?---oil is not "thick" enough and not enough "pressure on the bearing" to keep the proper spacing between bearing and crank
|
|
|
|
|
08-22-2021, 12:33 PM
|
#7 | |
|
Senior Member
Join Date: Apr 2020
Location: Phila, PA
Posts: 793
Likes: 0
Liked 733 Times in 384 Posts
|
Re: Micro Welding of bearing shell to rod housing bore
Quote:
Larry, Are you saying the Micro Welding is happening near the ends of the bearing? Stan |
|
|
|
|
 |
|
|
Hybrid Mode
