|
|
01-12-2014, 01:03 PM
|
#1 |
|
VIP Member
Join Date: Feb 2006
Location: Dela-where?
Posts: 2,193
Likes: 1,160
Liked 1,877 Times in 577 Posts
|
oil filter base question
I am assembling an aluminum block brodix big block. (I know this is not stock or super stock but you guys have great knowledge). I need to get a spin on filter base. what should I use? I was looking at CVS-OFA65 - CVR Spin-On Filter Mounts. is this what I need, and what about the bypass, should race engines always have that blocked? or any better suggestions? thanks, keith
__________________
KEITH MAYERS 2-1/2 X somebody Still many X nobody |
|
|
|
01-14-2014, 09:41 AM
|
#2 |
|
VIP Member
Join Date: Oct 2008
Location: Somerset,Ky
Posts: 1,371
Likes: 352
Liked 304 Times in 102 Posts
|
Re: oil filter base question
Several companies have replacement oil filter bases that are billet alum.,I never have had one of the GM cast ones fail,but billet ones are probaly good ideal and not bad cost,I need to order some instead of digging out GM cleaning it up and plugging bypass.
I always plug the bypass (racing)does'nt take much pressure to open it,and have some unfiltered oil I know Canton,Moroso also have them Mike Taylor 3601 |
|
|
|
 |
|
|
Linear Mode
