Windshield Washer Message

FrankChastain · 10-25-2014, 08:09 AM

Need some help on a 07 5.3 GMC Sierra pickup. The warning message comes on the windshield washer is low every time I start it up, but it's not
it's full. Goes off when I reset the mileage. Any help would be appreciated.

FrankChastain

Rob Petrie E395 · 10-26-2014, 01:25 AM

Take a look at the sensor in the tank. It probably has something on it. After you clean it or replace it ( I would recommend replacing it). IF you dont have a scan tool to reset it. Sometimes you can disconnect the battery for 2-4 hours and it will reset. While you are at it take a look at the connector in the wiring harness and make sure it is not corroded. If it is you can get a new one from NAPA.

FrankChastain · 10-26-2014, 06:20 AM

Quote:

Originally Posted by Rob Petrie E395

Take a look at the sensor in the tank. It probably has something on it. After you clean it or replace it ( I would recommend replacing it). IF you dont have a scan tool to reset it. Sometimes you can disconnect the battery for 2-4 hours and it will reset. While you are at it take a look at the connector in the wiring harness and make sure it is not corroded. If it is you can get a new one from NAPA.

Thanks Rob for the info.....Thanks again Frank

10-25-2014, 08:09 AM	#1
FrankChastain Senior Member Join Date: Mar 2009 Location: Trussville, Alabama-Originally from Vidalia,GA Posts: 642 Likes: 9 Liked 3 Times in 3 Posts	Windshield Washer Message *Need some help on a 07 5.3 GMC Sierra pickup. The warning message comes on the windshield washer is low every time I start it up, but it's not* *it's full. Goes off when I reset the mileage. Any help would be appreciated.* *FrankChastain*

10-26-2014, 01:25 AM	#2
Rob Petrie E395 VIP Member Join Date: Dec 2007 Location: Woodlawn IL Posts: 1,092 Likes: 162 Liked 216 Times in 77 Posts	Re: Windshield Washer Message Take a look at the sensor in the tank. It probably has something on it. After you clean it or replace it ( I would recommend replacing it). IF you dont have a scan tool to reset it. Sometimes you can disconnect the battery for 2-4 hours and it will reset. While you are at it take a look at the connector in the wiring harness and make sure it is not corroded. If it is you can get a new one from NAPA. Last edited by Rob Petrie E395; 10-26-2014 at 01:29 AM.