Opinions on stocker 30x9 radial slicks

Myron Piatek · 10-31-2009, 04:44 PM

I never ran screws and never had a problem. But the slicks may rotate several inches through the first several runs, then "settle in". I put a shoe polish mark on the tire next to the valve stem to gauge any movement. Swapping tires from side-to-side between races could help get it back closer to the original location. If you are nit-picky, you can always check the balance again after it "settles". But it's usually not noticable.

10-31-2009, 04:44 PM	#11
Myron Piatek VIP Member Join Date: Nov 2001 Location: Florida Posts: 1,542 Likes: 34 Liked 138 Times in 51 Posts	Re: Opinions on stocker 30x9 radial slicks I never ran screws and never had a problem. But the slicks may rotate several inches through the first several runs, then "settle in". I put a shoe polish mark on the tire next to the valve stem to gauge any movement. Swapping tires from side-to-side between races could help get it back closer to the original location. If you are nit-picky, you can always check the balance again after it "settles". But it's usually not noticable. __________________ LOCOMOTION Racing

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode