Epoxy question

NHRA 303 · 12-18-2015, 02:37 PM

Hello all. And Merry Christmas. I have my clutch sensor magnet in the input shaft of my G-101A G-Force trans. This past season it got loose and came out. And it ruined my Racepak sensor. Instead of shipping it back to G-Force to have the magnet reinstalled. Im just going to epoxy it back in myself. They were not sure on which type of Devcon epoxy they use. But it was a non-shrinking type. And was one that would not become hard, and brittle. Im thinking its one of the slower curing ones.
Any suggestions on which type? Or maybe another brand. I just dont want the magnet to come loose again. And ruin another $130 sensor. And i really dont want it to get loose in the gear case. I was fortunate this time.

Thank you all so much in advance,

Steve Tucholsky

12-18-2015, 02:37 PM	#1
NHRA 303 Junior Member Join Date: Feb 2013 Location: cleveland ,ohio Posts: 40 Likes: 1 Liked 0 Times in 0 Posts	Epoxy question Hello all. And Merry Christmas. I have my clutch sensor magnet in the input shaft of my G-101A G-Force trans. This past season it got loose and came out. And it ruined my Racepak sensor. Instead of shipping it back to G-Force to have the magnet reinstalled. Im just going to epoxy it back in myself. They were not sure on which type of Devcon epoxy they use. But it was a non-shrinking type. And was one that would not become hard, and brittle. Im thinking its one of the slower curing ones. Any suggestions on which type? Or maybe another brand. I just dont want the magnet to come loose again. And ruin another $130 sensor. And i really dont want it to get loose in the gear case. I was fortunate this time. Thank you all so much in advance, Steve Tucholsky __________________ Steve Tucholsky

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode