Schubeck Lifter Update

[Cam]

Originally Posted by NHRAstocker409

Lots, Todd.... 250+ seat / 470+ open... .508" / .516" lift mechanical ( .014" / .018" lash ).

In my conversation with the fellow from Performance Research, he suggested that my spring pressure may not cure the problem, but rather it could be due to the "frequency" / harmonics.
I'm going to be sending him a complete "package" that runs on my cam. He says they have a spintron / computer setup / program that will identify the issue ( if any ), and provide the info needed to correct it. Variable rate valve springs, with actually LESS pressure.
Less pressure makes me happy !

Like I said.... I will be going to the tool steel parts.
Decided to replace pistons too. At the end of the honing, I will be at .075" over, and WAY too much piston-to-wall ( .012" - .013" ). I like .009"

Thanks Todd

Aubrey :
I have set my Schebecks at .003" and have had no trouble. I wonder if the extra clearance is allowing the "pucks" to get hammered too hard?
What does everybody use for clearance with these lifters?
Cam
NHRA 6067