Opinions or experience with ISKY E-Z roll lifters

[carl hinkson]

Originally Posted by Mark Markow

you mean the isky's? I haven't had any issues with the crower.

This thread I started was about Crower .903 lifters 3 sets that could not be used.

Crower 842. lifters run right at .841 to small for any GM lifter bore that is .844 which gives you .003 clearance which is to much.

Here it a good video to look over.


I deal with a lot of blocks and check and machine alot of lifters and lifters bores when I machine blocks and have seen about every lifter out there.