03-05-2016, 10:59 AM
|
#7
|
|
Senior Member
Join Date: Dec 2001
Location: Elysburg, Pa
Posts: 733
Likes: 361
Liked 327 Times in 121 Posts
|
Re: Milling 624 Heads
Quote:
Originally Posted by Mike Taylor 3601
I setup to mill the whole head,when setting up check with dial indicator so there is the amount of angle you want, I.E. zero at exhaust side and .125'' at intake side of end rail,that should be right at .125'' angle mill, if still use stones on mill then it will take more than that by the handwheel because stone loss,but it should be .125'' removed from head although handwheel will show more.
You can mill and leave end rails uncut and seal with silicone,but I always try to mill whole head less chance for leaks.
Mike Taylor 3601
|
What part of the head is called the end rails.
.
|
|
|
Threaded Mode