Cragar stud hole size?

rod · 02-09-2017, 08:56 PM

I have a pair of Cragar S/S rims which are direct drilled for a 5 on 4 3/4 circle using 7/16 studs. I need to drill the studs holes out because I now have 1/2 inch studs and the nuts have a larger OD shank. the shank is .732 and the closest drill is a 47/64th at .734. next is a 3/4 at .750.
my dilemma is this: is .734 to tight or is .750 to loose.
Cragar does not have a phone #, so I cant contact them.
first race is Saturday next. so I need to get this done asap.
thoughts or ideas.
thanks Rod in AZ

02-09-2017, 08:56 PM	#1
rod Member Join Date: Dec 2009 Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66 Posts: 314 Likes: 0 Liked 20 Times in 15 Posts	Cragar stud hole size? I have a pair of Cragar S/S rims which are direct drilled for a 5 on 4 3/4 circle using 7/16 studs. I need to drill the studs holes out because I now have 1/2 inch studs and the nuts have a larger OD shank. the shank is .732 and the closest drill is a 47/64th at .734. next is a 3/4 at .750. my dilemma is this: is .734 to tight or is .750 to loose. Cragar does not have a phone #, so I cant contact them. first race is Saturday next. so I need to get this done asap. thoughts or ideas. thanks Rod in AZ