|
|
03-13-2019, 10:32 AM
|
#7 |
|
Senior Member
Join Date: Sep 2007
Location: Henderson, NV
Posts: 584
Likes: 9
Liked 54 Times in 27 Posts
|
Re: bellhoushing
I have had to use offset dowels and also correct in and out being off square. I use Lakewood dowels drilled and tapped 5/16 x 18 so I can remove them with a slide hammer. I have gotten some pretty bad alignments to within .001" by carefully orienting the dowels. Yes, I also have found QT to be much better than the old Lakewoods, but still the block is often not close enough.
|
|
|
|
|
Threaded Mode