Welding Thrust on Cast Crank?

[1347]

Originally Posted by GTX JOHN

Good Idea and I know it works and is available on some GM stuff
but I have not been able to find anything for my Mopar Stuff.

It seems like we have had a lot of problems since we started
leaving two steps. Plus my son is a serial gas whomper near
the finish!

Don't know how worn it is, but the King bearing I use for my small block ford application is always too tight and needs to be sanded down. Just used a King bearing on a friend's small block ford engine that was over .018, and the King bearing out of the box worked well.