5.0 stocker rear control arm bushings

west coast · 06-14-2009, 08:10 AM

BMR fabrication Inc. has nice looking stuff with Teflon lined spherical bearings they are the nice ones out there I could find. I had to fab my own up, bearings were only about 7 bucks each from Midwest controls. Have you trimmed the front and rear of your wheel openings yet I was able to take out about an 1 1/2" off the front and some off the rear to help make the 30" radials fit nicely.

06-14-2009, 08:10 AM	#5
west coast Senior Member Join Date: Dec 2008 Location: Rainy Washington Posts: 609 Likes: 12 Liked 223 Times in 73 Posts	Re: 5.0 stocker rear control arm bushings BMR fabrication Inc. has nice looking stuff with Teflon lined spherical bearings they are the nice ones out there I could find. I had to fab my own up, bearings were only about 7 bucks each from Midwest controls. Have you trimmed the front and rear of your wheel openings yet I was able to take out about an 1 1/2" off the front and some off the rear to help make the 30" radials fit nicely.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode