Cylinder head question,again.

Jody Lang · 09-07-2009, 11:06 AM

I should start a new thread for this, but I'll start here. There's a problem in the specs for the Stockers. I personally know of 4 people that have checked their runners and all 4 have been big on the exhaust. These are various Chev motors. In 3 of these it's only been 1 of the heads that's been big.

These are not acid heads either. The specs were for the Super Stock heads. Those that could braze/epoxy in the ports to get the desired CC's.

The new rule is affecting innocent racers that just assume their ports are ok because they're stock.

09-07-2009, 11:06 AM	#5
Jody Lang Member Join Date: Mar 2002 Posts: 307 Likes: 28 Liked 92 Times in 29 Posts	Re: Cylinder head question,again. I should start a new thread for this, but I'll start here. There's a problem in the specs for the Stockers. I personally know of 4 people that have checked their runners and all 4 have been big on the exhaust. These are various Chev motors. In 3 of these it's only been 1 of the heads that's been big. These are not acid heads either. The specs were for the Super Stock heads. Those that could braze/epoxy in the ports to get the desired CC's. The new rule is affecting innocent racers that just assume their ports are ok because they're stock.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode