|
|
![]() |
#1 | |||
Member
Join Date: Nov 2008
Location: Rudy, AR
Posts: 125
Likes: 0
Liked 0 Times in 0 Posts
|
![]() Quote:
Quote:
With current chassis certification. I suggest lower than 8.50 if you are going with a door car. With the crate engines out there it is very easy to run better than 8.50. Same with a dragster, it is very easy to go very fast these days. Quote:
Steve
__________________
Steve Prado Rudy, AR S/ST4202 H/R 4203 |
|||
![]() |
![]() |
![]() |
#2 | |
VIP Member
Join Date: Feb 2009
Location: Dunnellon,FL
Posts: 1,103
Likes: 0
Liked 4 Times in 4 Posts
|
![]() Quote:
Exactly! In building my car I ended up $20,000.00 over expected budget. If you buy one running be sure to get the engine spec's, cam, springs, timing, ring type, etc. nothing is worse than not knowing the clearances and trying to set the valves without knowing the gap for that cam shaft. Good luck, see you at the track. JimR
__________________
Jim Rountree |
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|