HOME FORUM RULES CONTACT
     
   
   

Go Back   CLASS RACER FORUM > Class Racer Forums > Stock and Super Stock Tech
Reload this Page Valve Job Question
Register Photo Gallery FAQ Members List Calendar Mark Forums Read

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-24-2009, 07:25 AM   #5
Mike Taylor 3601
VIP Member
 
Mike Taylor 3601's Avatar
 
Join Date: Oct 2008
Location: Somerset,Ky
Posts: 1,372
Likes: 358
Liked 308 Times in 103 Posts
Default Re: Valve Job Question
I was going to reply yesterday but I'm not sure I can answer correctly,I was told you can cut the bowl area down to guide area any angles but I would double check before I did anything.
Mike Taylor 3601
Mike Taylor 3601 is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 03:21 AM.

Class Racer - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.