Housing girdle for 8.75"; yes, or no?

[bill dedman]

Originally Posted by Philip Saran

If you run Chrysler S/S springs you will need to redo the spring hangers
to get the pinion angle correct. Spacer wedges only do so much.

I now have another 8-3/4 housing with the back brace and the spring pads
redone to correct that problem.

Phil,
We are putting replacement spring pads on the housing, (I know, that's not hangers) and will try to get the pinion angle correct at that time. I said TRY... lol!

Thanks for the advice!!!

[Philip Saran]

Originally Posted by bill dedman

Phil,
We are putting replacement spring pads on the housing, (I know, that's not hangers) and will try to get the pinion angle correct at that time. I said TRY... lol!

Thanks for the advice!!!

Bill, I stand corrected, it is the spring pads that get changed NOT the hangers.
I had a "B" body 8-3/4 housing cut down to stock "A" body width added a back
brace and new spring pads, just need to swap housings in the car.