My Teardown @ St Louis.....

ron mattson · 05-03-2010, 09:17 AM

Travis made a very good point about rocker arms, i was in teardown a few years ago and
just ripped the rockers off in a hurry not paying attention to where they came from and got
them mixed up, well my lift gets checked and came out exactly on to the thousandth but
the thing was .06-.008 to the good at home and i couldnt figure out why my result was any
different. now all rockers come off and get set in sequence as they vary a little.

05-03-2010, 09:17 AM	#24
ron mattson Member Join Date: Nov 2005 Location: cloquet mn Posts: 466 Likes: 17 Liked 67 Times in 30 Posts	Re: My Teardown @ St Louis..... Travis made a very good point about rocker arms, i was in teardown a few years ago and just ripped the rockers off in a hurry not paying attention to where they came from and got them mixed up, well my lift gets checked and came out exactly on to the thousandth but the thing was .06-.008 to the good at home and i couldnt figure out why my result was any different. now all rockers come off and get set in sequence as they vary a little. __________________ Ron Mattson 5015 STK

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode