Pinion angle

Greg Barsamian · 06-24-2010, 08:42 AM

Dion make sure to check the upper control arm cross member for stress cracks, particularly at each side that attach to the main frame!
Greg

Dion Hildebrandt · 06-24-2010, 10:56 AM

Yes Greg I have and all mounting points look a-ok, it would seem my failure of driveshafts would be that I am(was) using a stock piece and it started whipping in third gear. ordered a m/w chromemoly shaft with 1350 yokes which is good to 8500 rpm hopefully problem solved! thanks for all the suggestions and clarifications they have been really helpful!

06-24-2010, 08:42 AM	#1
Greg Barsamian VIP Member Join Date: Jan 2002 Location: Central Massachusetts Posts: 1,402 Likes: 728 Liked 427 Times in 97 Posts	Re: Pinion angle Dion make sure to check the upper control arm cross member for stress cracks, particularly at each side that attach to the main frame! Greg

06-24-2010, 10:56 AM	#2
Dion Hildebrandt Member Join Date: Nov 2008 Location: calgary alberta canada Posts: 383 Likes: 0 Liked 0 Times in 0 Posts	Re: Pinion angle Yes Greg I have and all mounting points look a-ok, it would seem my failure of driveshafts would be that I am(was) using a stock piece and it started whipping in third gear. ordered a m/w chromemoly shaft with 1350 yokes which is good to 8500 rpm hopefully problem solved! thanks for all the suggestions and clarifications they have been really helpful! __________________ Dion Hildebrandt 6009 STK H/SA

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode